High Power CC2650 CC2592 ZigBee/BLE module

N704HS CC2650 ZigBee /BLE module based TI 2.4 GHz wireless mcu CC2650 and CC2592, the module designed for 2.4G band

Zigbee/BLE. It can be debug or program by customizer. The CC2650 module has +22 dBm output power and the sensitivity down to -102 dBm at 250 kbps(for ZigBee). The module support Zigbee 3.0 ,BLE 5.0 and thread and so on.

The CC2650 Module has a small encapsulation(35 x 18 x 3 mm), Integrated CC2650 , CC2592 and pcb antenna, it reduced a lot of development troubles.

N704CS module hardware is designed for maximum range, 500m + Range (Low rate and Line of Sight).

CC2650 Features

• Powerful 48MHz Arm Cortex-M33 processor with TrustZone

• FPU and DSP extension

• 1024kB flash program memory

• 8kB of cache SRAM

• 256kB of ultra-low leakage SRAM with parity for high-reliability operation­32kB of additional SRAM if parity is disabled

• Dynamic multiprotocol manager (DMM) driver

• Programmable radio includes support for 2- (G)FSK, 4-(G)FSK, MSK, Bluetooth® 5.3 Low Energy, IEEE 802.15.4 PHY, and MAC

• Supports over-the-air update (OTA)

• Ultra-low power sensor controller

• Autonomous MCU with 4kB of SRAM

• Sample, store, and process sensor data

• Fast wake-up for low-power operation

• Software defined peripherals; capacitive touch, flow meter, LCD

N704HS CC2650 Wireless protocols

• Bluetooth® 5.0 Low Energy

• 6LoWPAN

• Proprietary Systems

N704HS CC2650 Module radio

• -106dBm for Bluetooth® Low Energy 125kbps

• -107dBm for IEEE 802.15.4-2006 2.4GHz OQPSK (coherent modem)

N704CS cc2674R10 Module UART baud

• UART baud up to 3Mbps.

N704HS Module Parameter

N704HS Pinout Description

How to used N704HS Module‍ ?

1. Debug

STEP 1:

connnect N704CS module to XDS110 V3 by wire.

STEP 2:

Used IAR or CCS 12 program it.

Note:

Please used the newest version.

2. RF test

step 1:

connect N704HS to XDS110

step 2:

1) Open smart RF studio 7,

2) Open CC2650 interface,

3) SET CC2592 IO

Then you can proceed with RF testing.

3. UART test

Download the uart2echo example fireware to CC2650 Module.

The table below indicates the serial port pins corresponding to GPIO.

4. GPIO test

Download the gpiointerrupt fireware to CC2650 module and run it:

Other example test please view the document.

File Download

CC2650 datasheet‍‍‍     

N704HS datasheet‍