High Power CC2652RB CC2592 ZigBee/BLE module

N704DS CC2652RB ZigBee /BLE module based TI 2.4 GHz wireless mcu CC2652RB and CC2592, the module designed for 2.4G band

Zigbee/BLE. It can be debug or program by customizer. The CC2652RB module has +22 dBm output power and the sensitivity down to -102 dBm at 250 kbps(for ZigBee). The module support Zigbee 3.0, BLE 5.2 and thread and so on.

The CC2652RB Module has a small encapsulation(35 x 18 x 3 mm), Integrated CC2652RB , CC2592 and pcb antenna, it reduced a lot of development troubles.

N704DS module hardware is designed for maximum range, 500m + Range (Low rate and Line of Sight).

cc2652RB Features

• Microcontroller

• Powerful 48 MHz Arm Cortex-M4F processor

• EEMBC CoreMark score: 148

• 352 kB of in-system programmable flash

• 256 kB of ROM for protocols and library functions

• 8 kB of cache SRAM (alternatively available as general-purpose RAM)

• 80 kB of ultra-low leakage SRAM. The SRAM is protected by parity to ensure high reliability of operation.

• 2-pin cJTAG and JTAG debugging

• Supports over-the-air (OTA) update

• Ultra-low power sensor controller with 4 kB of SRAMSample, store, and process sensor data

• Operation independent from system CPU

• Fast wake-up for low-power operation

• TI-RTOS, drivers, bootloader, Bluetooth 5.2 low energy controller, and IEEE 802.15.4 MAC in ROM for optimized application size

N704DS cc2652RB Wireless protocols

• Bluetooth® 5.2 Low Energy

• 6LoWPAN

• Proprietary Systems

• ZigBee

N704DS CC2652RB Module radio

• -106dBm for Bluetooth® Low Energy 125kbps

• -107dBm for IEEE 802.15.4-2006 2.4GHz OQPSK (coherent modem)

N704DS CC2652RB Module UART baud

• UART baud up to 3Mbps.

N704DS Module Parameter

N704DS Pinout Description

How to used N704DS Module ?

1. Debug

STEP 1:

connnect N704DS module to XDS110 V3 by wire.

STEP 2:

Used IAR or CCS 12 program it.

Note:

Please used the newest version.

2. RF test

step 1:

connect N704DS to XDS110

step 2:

1) Open smart RF studio 7,

2) Open CC2652RB interface,

3) SET CC2592 IO

Then you can proceed with RF testing.

3. UART test

Download the uart2echo example fireware to CC2652RB   Module.

The table below indicates the serial port pins corresponding to GPIO.

4. GPIO test

Download the gpiointerrupt fireware to CC2652RB module and run it:

Other example test please view the document.

File Download

CC2652RB datasheet‍‍‍     

N704DS datasheet‍