5 Milliwatts ZigBee/BLE CC2674R10 Dongle

N732CP CC2674R10 Zigbee /BLE Dongle based TI CC2674R10 2.4 GHz wireless mcu , and USB to uart chip, the Zigbee/BLE dongle designed for 2.4G band. It can be debug or program by customize. The CC2674R10 dongle has +5 dBm output power and the sensitivity down to -100 dBm at 250 kbps. The dongle support Zigbee 3.2 ,BLE 5.3 and thread and so on.

The CC2674R10 Dongle has a small private USB shell, Integrated buttons and dual color LED 3528, CC2674r10, cp2102 and pcb antenna, with the specialized custom shell, it reduced a lot of development troubles, Only the most software programming is needed to quickly push it to the market. Suitable for 802.15.4 edge gateways, sniffers, packet catchers, etc. The USB shell is compact and exquisite, suitable for personal or commercial use. Can be OEM/ODM. The length, width, and height of the shell are 45 x 19 x 8 mm. The color of the shell and buttons can be customized.

N732CP dongle hardware is designed for maximum range, 100m + Range (Low rate and Line of Sight).

The N732CP Private Shell By Coral RF

cc2674R10 Features

• Powerful 48MHz Arm Cortex-M33 processor with TrustZone

• FPU and DSP extension

• 1024kB flash program memory

• 8kB of cache SRAM

• 256kB of ultra-low leakage SRAM with parity for high-reliability operation­32kB of additional SRAM if parity is disabled

• Dynamic multiprotocol manager (DMM) driver

• Programmable radio includes support for 2- (G)FSK, 4-(G)FSK, MSK, Bluetooth® 5.3 Low Energy, IEEE 802.15.4 PHY, and MAC

• Supports over-the-air update (OTA)

• Ultra-low power sensor controller

• Autonomous MCU with 4kB of SRAM

• Sample, store, and process sensor data

• Fast wake-up for low-power operation

• Software defined peripherals; capacitive touch, flow meter, LCD

N732CP cc2674R10 Wireless protocols

• Bluetooth® 5.3 Low Energy

• 6LoWPAN

• Proprietary Systems

N732CP cc2674R10 Dongle radio

• -104dBm for Bluetooth® Low Energy 125kbps

• -105dBm for IEEE 802.15.4-2006 2.4GHz OQPSK (coherent modem)

N732CP cc2674R10 Dongle UART baud

• UART baud up to 3Mbps.

N732CP cc2674R10 Dongle Parameters

How to used N732CP Dongle‍ ?

1. KEY, LED, DEBUG, SWITCH port circult

1) KEY circult

2) LED circult

3) Debug Port

4, UART port

2. RF test

step 1:

connect N732CP to XDS110

step 2:

1) Open smart RF studio 7,

2) Open cc2674R10 interface,

Then you can proceed with RF testing.

3. UART test

step 1:

Download the fireware to cc2674R10

step 2:

install CP2102 driver

step 3:

send the data from putty, then can receive data from N732CP dongle.

Download

CC2674R10 datasheet‍‍‍     

N732CP datasheet

CP2102 DRIVER‍