2400MHz Transceiver CC2510 with PA RF Module

N209AS radio module based TI CC2510 transceiver and CC2592, up to 20 dBm output power, designed for 2400 - 2483.5 MHz band. AT command support.

The CC2510 CC2592 module's antenna port( PCB antenna and IPEX ) is matched to 50 Ohm impedance well. Users needn't to design RF circuit. And user needn't to spend time to choose suitable antennas.   

N209AS operates at 1.8~3.6V voltage and very low current which makes theRF modules suitable for battery-powered. The module leads all pins out of cc2510 for secondary development.

N209AS Parameters

CC2510 transceiver feature

The CC2510Fx is a true low-cost 2.4 GHz system-on-chip (SoC) designed for lowpower wireless applications. The CC2510Fx combines the excellent performance of the state-of-the-art RF transceiver CC2500 with an industry-standard enhanced 8051 MCU, up to 32 kB of in-system programmable flash memory and 4 kB of RAM, and many other powerful features. The small 6x6 mm package makes it very suited for applications with size limitations.

The CC2510Fx is highly suited for systems where very low power consumption is required. This is ensured by several advanced low-power operating modes. The CC2511Fx adds a full-speed USB controller to the feature set of the CC2510Fx. Interfacing to a PC using the USB interface is quick and easy, and the high data rate (12 Mbps) of the USB interface avoids the bottlenecks of RS-232 or low-speed USB interfaces.

• Radio

  • High-performance RF transceiver based on the market-leading CC2500

  • Excellent receiver selectivity and blocking performance

  • High sensitivity (−103 dBm at 2.4 kBaud)

  • Programmable data rate up to 500 kBaud

  • Programmable output power up to 1 dBm for all supported frequencies

  • Frequency range: 2400 - 2483.5 MHz

  • Digital RSSI / LQI support

• Current Consumption

  • Low current consumption (RX: 17.1 mA @ 2.4 kBaud,
    TX: 16 mA @ −6 dBm output power)

  • 0.3 µA in PM3 (the operating mode with the lowest power consumption)

• MCU, Memory, and Peripherals

  • High performance and low power 8051 microcontroller core.

  • 8/16/32 kB in-system programmable flash, and 1/2/4 kB RAM

  • Full-Speed USB Controller with 1 kB USB FIFO (CC2511Fx)

  • I2S interface

  • 7 – 12 bit ADC with up to eight inputs

  • 128-bit AES security coprocessor

  • Powerful DMA functionality

  • Two USARTs

  • 16-bit timer with DSM mode

  • Three 8-bit timers

  • Hardware debug support

  • 21 (CC2510Fx ) or 19 (CC2511Fx ) GPIO pins

• General

  • Wide supply voltage range (2.0V - 3.6V)

N209AS PCB layout information