500 Milliwatts 868M 915MHz CC1200 CC1190 Wi-SUN Module

N516CS CC1200 CC1190 Wi-SUN module based TI CC1200 Sub GHz transceiver, CC1190 and TCXO, the Wi-SUN module designed for 868M and 915Mhz band. It can be changed registers by SPI port. The CC1200 CC1190 module has +27 dBm output power and the sensitivity down to -112 dBm at 50 kbps. The module support Arduino and Wi-SUN.

N516CS base TI boostxl-cc1120-90. The CC1200 CC1190 module has SMD and plug-in installation mode.The module use narrowband FSK modulation. The FSK Wi-SUN module N516CS occupies very little bandwidth. Using MCU to control this module can change transmission power, bandwidth and air rate through CC1200 registers. The frequency band supported by the module is 860 - 880 MHz and 910 - 960 MHz. The module supports two types of antenna interfaces, RF pin and SMA seat. The module supports FCC and CE certification.

N516CS module hardware is designed for maximum range, 10000m + Range (Low rate and Line of Sight).

Wireless protocols

IEEE 802.15.4g, Sigfox, Narrowband network, WM-Bus, WiSUN®, SimpleLink™ TI 15.4 stack (Sub-1 GHz).

N516CS CC1200 CC1190 Module Parameters

N516CS pinout Description

N516CS CC1200 CC1190 Module typical application circuit

N516CS Module Package

N516CS Module Packaging Diagram

Download

CC1200 driver‍‍     

N516CS datasheet

CC1200 datasheet

Ordering information

N516CS-868M     CC1200+CC1190     +27 dBm, Wi-SUN, 860-880 MHz

N516CS-915M     CC1200+CC1190     +27 dBm, Wi-SUN, 910-960 MHz

CC1200 Description

The CC1200 device is a fully integrated single-chip radio transceiver designed for high performance at very low-power and low-voltage operation in cost-effective wireless systems. All filters are integrated, thus removing the need for costly external SAW and IF filters. The device is mainly intended for Industrial, Scientific, and Medical (ISM) applications and Short Range Device (SRD) frequency bands at 164 to 192 MHz, 274 to 320 MHz, 410 to 480 MHz, and 820 to 960 MHz.

The CC1200 device provides extensive hardware support for packet handling, data buffering, burst transmissions, clear channel assessment, link quality indication, and wake-on-radio. The main operating parameters of the CC1200 device can be controlled through an SPI interface. In a typical system, the CC1200 device is used with a microcontroller and only a few external passive components.

CC1190 Description

CC1190 is a cost-effective and high-performance RF Front End for low-power and low-voltage wireless applications at 850 - 950 MHz.CC1190 is a range extender for the sub-1 GHz low-power RF transceivers, transmitters, and System-on-Chip devices from Texas Instruments.CC1190 integrates a power amplifier (PA), a low-noise amplifier (LNA), switches, and RF matching for the design of a high-performance wireless systems.CC1190 increases the link budget by providing a power amplifier for increased output power, and an LNA with low noise figure for improved receiver sensitivity.