500 Milliwatts 868M 915MHz CC1125 CC1190 Module

N516BS CC1125 CC1190 narroband module based TI CC1125 transceiver ,CC1190 and TCXO, the module designed for 868M and 915Mhz narrowband band. It can be changed registers by SPI port. The CC1125 CC1190 module has +27 dBm output power and the sensitivity down to -126 dBm at 1.2 kbps.

N516AS CC1125 CC1190 module has SMD and plug-in installation mode.The module use narrowband FSK modulation. The FSK narrowband module N516AS occupies very little bandwidth. Using MCU to control this module can change transmission power, bandwidth and air rate through CC1120 registers. The frequency band supported by the module is 860 - 880 MHz and 910 - 960 MHz. The   module supports two types of antenna interfaces, RF pin and SMA seat. The module supports FCC and CE certification.

N516AS CC1125 CC1190 module hardware is designed for maximum range, 10000m + Range (Low rate and Line of Sight).

Wireless protocols

IEEE 802.15.4g, Sigfox, Narrowband network, WM-Bus, WiSUN®, SimpleLink™ TI 15.4 stack (Sub-1 GHz).

N516BS CC1125 CC1190 Module Parameters

N516BS pinout Description

N516BS CC1125 CC1190 Module typical application circuit

N516BS Module Package

N516BS Module Packaging Diagram

Software code example‍     

datasheet N516 download

Download CC1125 datasheet

Ordering information

N516BS-868M     CC1125+CC1190     +27 dBm, Narrowband, 860-880 MHz

N516BS-915M     CC1125+CC1190     +27 dBm, Narrowband, 910-960 MHz

CC1125 Description

The CC1125 device is a fully integrated single-chip radio transceiver designed for high performance at very low-power and low-voltage operation in cost-effective wireless systems. All filters are integrated, thus removing the need for costly external SAW and IF filters. The device is mainly intended for the ISM (Industrial, Scientific and Medical) and SRD (Short Range Device) frequency bands at 164–192 MHz, 274–320 MHz, 410–480 MHz, and 820–960 MHz.

The CC1125 device provides extensive hardware support for packet handling, data buffering, burst transmissions, clear channel assessment, link quality indication, and Wake-On-Radio. The main operating parameters of the CC1125 device can be controlled through an SPI interface. In a typical system, the CC1125 device will be used with a microcontroller and only a few external passive components.

CC1190 Description

CC1190 is a cost-effective and high-performance RF Front End for low-power and low-voltage wireless applications at 850 - 950 MHz.CC1190 is a range extender for the sub-1 GHz low-power RF transceivers, transmitters, and System-on-Chip devices from Texas Instruments.CC1190 integrates a power amplifier (PA), a low-noise amplifier (LNA), switches, and RF matching for the design of a high-performance wireless systems.CC1190 increases the link budget by providing a power amplifier for increased output power, and an LNA with low noise figure for improved receiver sensitivity.