5 Milliwatts ZigBee/BLE CC2652RB Dongle

N732DP CC2652RB Zigbee /BLE Dongle based TI CC2652RB 2.4 GHz wireless mcu and USB to uart chip, the Zigbee/BLE dongle designed for 2.4G band. It can be debug or program by customizer. The CC2652RB dongle has +5 dBm output power and the sensitivity down to -100 dBm at 250 kbps. The dongle support Zigbee 3.0 ,BLE 5.2 and thread and so on.

The CC2652RB Dongle has a small private USB shell, Integrated buttons and dual color LED 3528, CC2652Rb, cp2102 and pcb antenna, with the specialized custom shell, it reduced a lot of development troubles, Only the most software programming is needed to quickly push it to the market. Suitable for 802.15.4 edge gateways, sniffers, packet catchers, etc. The USB shell is compact and exquisite, suitable for personal or commercial use. Can be OEM/ODM. The length, width, and height of the shell are 45 x 19 x 8 mm. The color of the shell and buttons can be customized.

N732DP dongle hardware is designed for maximum range, 100m + Range (Low rate and Line of Sight).

The N732DP Private Shell By Coral RF

cc2652RB Features

• Powerful 48-MHz Arm Cortex-M4F processor

• EEMBC CoreMark score: 148

• 352KB of in-system programmable flash

• 256KB of ROM for protocols and library functions

• 8KB of cache SRAM (alternatively available as general-purpose RAM)

• 80KB of ultra-low leakage SRAM. The SRAM is protected by parity to ensure high reliability of operation.

• 2-pin cJTAG and JTAG debugging

• Supports over-the-air (OTA) update

N732DP CC2652RB Wireless protocols

• Thread,

• Zigbee,

• Bluetooth 5.2 Low Energy,

• IEEE 802.15.4,

• IPv6-enabled smart objects (6LoWPAN),

• proprietary systems,

• SimpleLink™ TI 15.4 stack (2.4 GHz),

• and dynamic multiprotocol manager (DMM) driver.

N732CP cc2674R10 Dongle radio

• -102dBm for Bluetooth® Low Energy 125kbps

• -100dBm for IEEE 802.15.4-2006 2.4GHz OQPSK (coherent modem)

N732DP CC2652RB Dongle UART baud

• UART baud up to 3Mbps.

N732DP CC2652RB Dongle Parameters

How to used N732DP Dongle?

1. N732DP CC2652RB Dongle KEY, LED, DEBUG, SWITCH port circult

1) KEY circult

2) LED circult

3) Debug Port

4, UART port

2. RF test

step 1:

connect N732DP to XDS110

step 2:

1) Open smart RF studio 7,

2) Open CC2652RB interface,

Then you can proceed with RF testing.

3. UART test

step 1:

Download the fireware to CC2652RB

step 2:

install CP2102 driver

step 3:

send the data from putty, then can receive data from N732DP dongle.

Download

CC2652RB datasheet‍‍‍     

N732DP datasheet

CP2102 DRIVER‍