2 Watt 868 / 915 MHz High Power CC1120 Narrowband Module

Introduction

TI CC1120 is designed for narrowband, very low-power and wireless transceiver. The RF transceiver is mainly used for the SRD ( Short Range Device) and ISM ( Scientific, car, Industrial, and Medical) . The frequency bands support 169, 220, 315, 433, 470, 868, and 915 MHz. And can changed CC1120 register easily be used for other frequencies in the 137.6-160 MHz, 164-192 MHz, 205-240MHz, 273.3-320 MHz, 410-480 MHz,and 820-960 MHz bands.

N513FS-CC1120 high power radio module based TI CC1120 narrowband transceiver, high power PA and LNA. The high power radio module has +33 dBm output power and - 126 dBm sensitivity (at 1.2 kbps). The module use AT command. The high power module is mainly for Internet of things, intelligent home, wireless meter reading, scientific research and medical treatment, and medium and long-distance wireless communication equipment. CC1120 module leads all pins out for secondary development. AT commands support.

N513FS Module, SPI and UART port, RF pin, SMD package, small size, the module is suitable for SMT production.

Model: N513FS-CC1120-868M

Features:

MCU Operating voltage : 2-3.6V

PA Operating voltage : 3-5.5V

• RF rate: 1.2 - 10 kbps, support 2-FSK modulation

• Relevant parameters such as baud rate, RX filter BW, radio frequency, and transmission power can be modified through software

• Sensitivity (<1.2kbps -126dBm, 1% packet error rate)

• CRC error detection and built-in hardware address multipoint communication control

• Lower RX current consumption (RX 27mA Peak Current in Low-Power Mode; 1.2 kbps, 868 MHz)

• Power Down (1uA)

• Programmable control of RF output power, maximum output power of +33 dBm

• SMD package for SMT

• Separate 128-byte RX and TX data FIFO

• Transmission distance: 10 - 15000 meters (Depending on the specific situation of the environment and RF baud rate, etc.)

Applications

Sigfox network or point-to-point long distance transmission.

Narrowband system

Arduino device

Narrowband Ultra-Low-Power Wireless Systems

IEEE 802.15.4g Systems

With Channel Spacing Down to 12.5 kHz

Wireless Alarm and Security Systems

169-, 315-, 433-, 868-, 915-, 920-, 950-MHz

Industrial Monitoring and Control ISM/SRD Band

Wireless Healthcare Applications

Wireless Metering and Wireless Smart Grid (AMR and AMI)

Wireless Sensor Networks and Active RFID

Private Mobile Radios

Home and Building Automation

N513FS is suitable for free frequency band in EU and America.

Usage

1. N513FS Typical Circult

Pin Definition

‍   

1.Test hardware

CC1120 module can be configured using CCdebugger and SmartRF™ Studio software. SmartRF™ Studio is highly recommended for obtaining optimum register settings, and for evaluating performance and functionality.

After chip reset by CCdebugger, all registers have default values and these might differ from the optimum register setting. It is therefore necessary to configure/reconfigure the radio through the SPI interface after the chip has been reset. SmartRF Studio provides a code export function making it easy to implement this in firmware.

2. CC1120 datasheet

    Download N513 datasheet

    Download CC1120 datasheet

‍

3. TX RX DEMO