20 Milliwatts CC1310 FSK Radio Dongle

N534AP CC1310 FSK radio Dongle based TI CC1310 SUB GHz wireless mcu, and USB to uart chip, the FSK radio dongle designed for   433M, 868M and 915M   band. It can be debug or program by customizer. The CC1310 wireless dongle has +14 dBm output power and the sensitivity down to -110 dBm at 50 kbps. The dongle support IEEE 802.15.4g, IPv6-enabled smart objects (6LoWPAN), MIOTY, Wireless M-Bus, Wi-

SUN, proprietary systems, SimpleLink™ TI 15.4 stack (Sub-1 GHz) and so on.

The CC1310 Dongle has a small private USB shell, Integrated buttons and dual color LED 3528, CC1310, cp2102 and pcb antenna, with the specialized custom shell, it reduced a lot of development troubles, Only the most software programming is needed to quickly push it to the market. Suitable for 802.15.4 edge gateways, sniffers, packet catchers, etc. The USB shell is compact and exquisite, suitable for personal or commercial use. Can be OEM/ODM. The length, width, and height of the shell are 45 x 19 x 8 mm. The color of the shell and buttons can be customized.

N534AP FSK radio dongle hardware is designed for maximum range, 1000m + Range (Low rate and Line of Sight).

The N534AP Private Shell By Coral RF

N534AP Master Chip CC1310 Features

• Powerful 48MHz Arm Cortex-M3 processor with TrustZone

• FPU and DSP extension

• 128kB flash program memory

• 8kB of cache SRAM

• 28kB of ultra-low leakage SRAM with parity for high-reliability operation­32kB of additional SRAM if parity is disabled

• Dynamic multiprotocol manager (DMM) driver

• Supports over-the-air update (OTA)

N534AP CC1310 Dongle Wireless protocols

• Wi-SUN®

• mioty®

• Amazon Sidewalk

• Wireless M-Bus

• SimpleLink™ TI 15.4-stack

• Proprietary systems

N534AP CC1310 Dongle radio performance

• -110dBm sensitivity at 50kbps

• up to 14dBm output power at 5V

N534AP CC1310 Dongle UART baud

• UART baud up to 115200bps.

N534AP CC1310 Dongle Parameters

How to used N534AP cc1310 Dongle ?

1. N534AP cc1310 dongle KEY, LED, DEBUG port circult

1) N534AP dongle KEY circult

2) N534AP dongle LED circult

3) N534AP dongle Debug Port

Note: for XDS110V3, only TCK and TMS used. For jtag, please view the guider of CC1310.

4) N534AP dongle UART port

    DIO3-->TXD;    DIO2<--RXD;

2. N534AP CC1310 Dongle RF test

step 1:

connect N534AP to XDS110

step 2:

1) Open smart RF studio 7,

2) Open CC1310 interface,

Then you can proceed with RF testing.

3. N534AP CC1310 Dongle UART test

step 1:

Download the fireware to N534AP cc1310 Dongle

step 2:

install CP2102 driver in your computer,secect VCP port.

step 3:

send the data from putty to VCP port, then can receive the same data from N534AP from dongle.

N534CP cc1312 Dongle Download

CC1310 datasheet

N7534AP datasheet

CP2102 DRIVER‍