100 Milliwatts ZigBee/BLE CC2652P Dongle

N730AP CC2652P Zigbee /BLE Dongle based TI CC2652P 2.4 GHz wireless mcu, USB to uart chip, the Zigbee/BLE dongle designed for 2.4G band. It can be debug for customize. The CC2652P dongle has +20 dBm output power and the sensitivity down to -100 dBm at 250 kbps. The dongle support Zigbee 3.0 ,BLE 5.2 and thread.

The CC2652P Dongle has a small USB package, Integrated buttons and dual color LED, cc2652p, cp2102 and antenna, with the specialized custom shell, it reduced a lot of development troubles.

N730AP dongle hardware is designed for maximum range, 500m + Range (Low rate and Line of Sight).

CC2652P Features

• MicrocontrollerPowerful 48MHz Arm Cortex-M4F processor

• EEMBC CoreMark score: 148

• 352kB of in-system programmable flash

• 256kB of ROM for protocols and library functions

• 8kB of cache SRAM (alternatively available as general-purpose RAM)

• 80kB of ultra-low leakage SRAM. The SRAM is protected by parity to ensure high reliability of operation.

• 2-pin cJTAG and JTAG debugging

• Supports over-the-air (OTA) update

• Ultra-low power sensor controller with 4kB of SRAMSample, store, and process sensor data

• Operation independent from system CPU

• Fast wake-up for low-power operation

• TI-RTOS, drivers, bootloader, Bluetooth 5.2 low energy controller, and IEEE 802.15.4 MAC in ROM for optimized application size

N730AP CC2652P Wireless protocols

• Thread,

• Zigbee ,

• Bluetooth 5.2 Low Energy,

• IEEE 802.15.4,

• IPv6-enabled smart objects (6LoWPAN),

• proprietary systems,

• SimpleLink™ TI 15.4 stack (2.4GHz), and dynamic multiprotocol manager (DMM) driver.

N730AP CC2652P Dongle UART baud

• UART baud up to 3Mbps.

N730AP CC2652P Dongle Parameters

How to used N730AP Dongle

1. KEY, LED, DEBUG, SWITCH port

1) KEY circult

2) LED circult

3) Debug Port

4, UART port

5, SWITCH circult

2. RF test

step 1:

connect N730AP to XDS110

step 2:

1) Open smart RF studio 7,

2) Open CC2652P interface,

3) SET SWITCH IO

Then you can proceed with RF testing.

3. UART test

step 1:

Download the fireware to CC2652P

step 2:

install CP2102 driver

step 3:

send the data from putty, then can receive data from N730AP dongle.

Download

CC2652P datasheet‍‍‍     

N730AP datasheet

CP2102 DRIVER‍