100 Milliwatts ZigBee/BLE CC2674P10 Dongle

N729AP CC2674P10 Zigbee /BLE Dongle based TI CC2674P10 2.4 GHz wireless mcu and USB to uart chip, the Zigbee/BLE dongle designed for 2.4G band. It can be debug or program by customize. The CC2674P10 dongle has +20 dBm output power and the sensitivity down to -100 dBm at 250 kbps. The dongle support Zigbee 3.0 ,BLE 5.2 and thread and so on.

The CC2674P10 Dongle has a small private USB shell, Integrated buttons and dual color LED 3528, cc2674p10, cp2102 and antenna, with the specialized custom shell, it reduced a lot of development troubles.

N729AP dongle hardware is designed for maximum range, 500m + Range (Low rate and Line of Sight).

The N729AP Private Shell By Coral RF

CC2674P10 Features

• Wireless microcontroller

• Powerful 48 MHz Arm Cortex-M33 processor with TrustZone

• FPU and DSP extension

• 1024 kB flash program memory

• 8 kB of cache SRAM

• 256 kB of ultra-low leakage SRAM with parity for high-reliability operation­32 kB of additional SRAM is available if parity is disabled

• Dynamic multiprotocol manager (DMM) driver

• Programmable radio includes support for 2- (G)FSK, 4-(G)FSK, MSK, Bluetooth® 5.3 Low Energy, IEEE 802.15.4 PHY and MAC

• Supports over-the-air upgrade (OTA)

• Ultra-low power sensor controller

• Autonomous MCU with 4 kB of SRAM

• Sample, store, and process sensor data

• Fast wake-up for low-power operation

• Software defined peripherals; capacitive touch, flow meter, LCD

N729AP CC2674P10 Wireless protocols

• Thread, Zigbee®, Matter

• Bluetooth® 5.3 Low Energy

• 6LoWPAN

• Proprietary Systems

N729AP CC2674P10 Dongle radio

• –104 dBm for Bluetooth® Low Energy 125 kbps

• –105 dBm for IEEE 802.15.4-2006 2.4 GHz OQPSK (coherent modem)

• Output power up to +20 dBm with temperature compensation

N729AP CC2674P10 Dongle UART baud

• UART baud up to 3Mbps.

N729AP CC2674P10 Dongle Parameters

How to used N729AP Dongle

1. KEY, LED, DEBUG, SWITCH port circult

1) KEY circult

2) LED circult

3) Debug Port

4, UART port

5, SWITCH circult

2. RF test

step 1:

connect N729AP to XDS110

step 2:

1) Open smart RF studio 7,

2) Open CC2674P10 interface,

3) SET SWITCH IO

Then you can proceed with RF testing.

3. UART test

step 1:

Download the fireware to CC2652P

step 2:

install CP2102 driver

step 3:

send the data from putty, then can receive data from N729AP dongle.

Download

CC2674P10 datasheet‍‍‍     

N729AP datasheet

CP2102 DRIVER‍